This is the headlight bucket-to-truck seal.... went in with a lot of silicone grease and a lot of fingering... my fingers where numb for a week (wuss)
anyways the signal light seal wasnt cooperating like the other seal...the part that goes into the trunk was so big that it didnt fit into the hole in the trunk .... even with lots of silicone grease and alot of fingering it didnt want to budge.... at last i after literally two hours... i shaved some of the rubber and got it in... then i looked at it and said WHAT THE HELL DID I DO???!! it looked terrible... i know nobody is going to notice it but.... sigh.... im not going to show you guys how it looks like here... anyways so the right side is in and i didnt want to do the same thing to the right side...
so... i used my brains this time and used a taped up small screw driver to drive the rubber into place... it worked and i didnt have to shave the rubber at all... although i did had to use a lot of force...... now if only i did that the first time with the left side...
here is the right side all nice and all....
here is the right side all nice and all.... 
No comments:
Post a Comment